I donot think whether this is right forum or not but I am looking for an individual who can help me in a small project of assembly language on behalf of my friend. Since I am not very much familiar with the micro controller used and have no time to understand the mnemonics of language to do this project therefore I am going to put this for open suggestions at this forum. If you have done assembly language projects before then it wont be a problem.

The assembly language project is for 68HC12 micro controller. Code warrior is the software which is to be used. I can send you the link for the download if you need.

Here are the details.
Write assembly code to simulate a microwave.
Requirements:
The user should enter the cooking time and then press start to cook. The door has to be closed in order to be able to cook. The user should be able to change various settings indicated by the peripherals below.

Use of peripherals:
1. Stepper-Motor:
Cooking (Speed indicates power level: Hi-Medium-Low-Off)

2. DC-Motor:
Vent Fan (Hi-Medium-Low-Off)

3. Keypad:
a) Select different options
b) To enter time
c) Enter power setting
d) Enter light settings
e) Enter vent fan settings

4. Potentiometer:
Temperature Sensor for the room (kitchen)
(The value of the Potentiometer should be scaled to be from 10-180)

5. LCD:
a) View options
b) View current temperature
c) View cooking time
d) View current settings

6. LEDs:
a) Outside Light (Bright-Night-Off)
b) Inside Light (On when door is open or cooking)

7. Switches:
To indicate if the door is open or closed

8. Speaker:
Beep when itâ200231s done, door is open or paused.

9. IRQ:
Pause

10. RTI

Note:
You can make some assumptions in the project development, but keep in mind that the assumptions must make sense to the user.

Note: This project needs to be done not more than 5-7 days if possible after the award of the project and it wont be an issue for a good coder in assembly language. My friend can provide with the notes used in class if you need. Since he is facing difficulties he might ask for tutoring as well once this project is over, so there is a good chance for more work. Do let me know if you can do this.